3 drums dryer 2.8x10m

Introduction of industrial biomass dryers

The triple pass rotary drum dryer is a new type of drying equipment. In order to reduce the floor space of drying equipment and improve the efficiency of the dryer. The equipment consists of three parts: the inner cylinder, the middle cylinder and the outer cylinder. System design Reasonable, well-produced, stable performance, advanced technology, high output, low energy consumption, small footprint and high degree of mechanization. After the improvement of applicability of our technical personnel, the effect is very good in the treatment of high-humidity materials

Performance Characteristics of sawdust dryer system

1.  Low outlet air temperature, longer service life of dust removal equipment.

2.  Sizes of lump materials, particles, and powders are less than 20mm can be dried.

3.  Gear driving is not required and it's directly driven by roller, with higher mechanical efficiency.

4.  Without the phenomenon of air leakage, the sealing difficulty is totally solved, and the installation can be finished within a few hours.

5.  50% of area covers has been reduced compared with the single drum dryer, and land investment reduced by 50%, power consumption reduced by 60%.

6. The self-insulation thermal efficiency of three-cylinder dryer can reach above 70% (the self-insulation thermal efficiency of traditional single drum dryer is only 35%), it has remarkable energy saving effect.

7.  Final moisture indicators can be regulated easily according to the request.

8.  Less than 1% of material moisture can be assured by the three-cylinder dryer, which is the preferred product for the dry mixed mortar and slag powder production line.

9. The temperature of discharged material is < 50 ?C, which can be directly conveyed into the storage silo, needless to cool down in the cooling shed.

When compare with Rotary Drum Dryer

* Using alloy steel plate, wear-resisting 3-4 times than ordinary steel plate.

* Reducing the floor area by about 50% compared to the single-cylinder dryer.

* The material is 15% and the final moisture content is ensured to be 0.5-1% or less.

* According to user requirements can easily regulate the desired final moisture index.

Technical Data